 |
Designed for safe and efficient handling of most petroleum- based products, Tygon® Fuel and Lubricant Tubing resists embrittlement, cracking and swelling. |
Formulation F-4040-A
A consistent performer lot after lot, Tygon® Fuel and Lubricant Tubing is the most requested fuel and lubricant tubing for a variety of applications — from small engine fuel lines to coolant transfer. Specifically designed to handle most fuels and industrial lubricants, Tygon® Fuel and Lubricant Tubing resists the swelling and hardening caused by hydrocarbon-based fluids. This significantly reduces the risk of failure due to cracking and leakage. Its minimum extractability safeguards the liquid or vapor being transferred against adulteration.
Extremely flexible (Shore A, 57), Tygon® Fuel and Lubricant Tubing simplifies installation, even in tight places. It is translucent yellow for positive identification and to allow easy flow monitoring. It is routinely used to handle gasoline, kerosene, heating oils, cutting compounds and glycol-based coolants.
Click here to view a data sheet with complete size chart.
Features/Benefits
- Resists embrittlement
- Compatible with most petroleum-based products
- Resists swelling and cracking
- Ozone and UV light resistant
- Contains no chemicals listed in California’s Prop 65
|
Typical Applications
- Small Engine Fuel Lines
- General Automotive
- Recreational Vehicles
- Lawn and Garden Equipment
- Coolant Transfer
- Heating Fuels
- Cutting Compounds
- Polishing equipment
- Lubricant Lines
|
Tygon® F-4040-A Tubing Typical Physical Properties
Property | ASTM Method |
Value or Rating |
Durometer Hardness - Shore A, 15 sec |
D2240 |
57 |
Color |
- |
Translucent Yellow |
Tensile Strength - psi (MPa) |
D412 |
1,820 (12.5) |
Ultimate Elongation, % |
D412 |
310 |
Tear Resistance - lb-f/inch (kN/m) |
D1004 |
167 (29) |
Specific Gravity |
D792 |
1.26 |
Water Absorption, % - 24 hours @ 23ºC |
D570 |
0.49 |
Compression Set Constant Deflection, % - @ 158ºF (70ºC) for 22 hours |
D395 - Method B |
65 |
Brittleness by Impact Temp - ºF (ºC) |
D746 |
-35 (-37) |
Max Recommended Operating Temp - ºF (ºC) |
- |
165 (74) |
Dielectric Strength - v/mil (kV/mm) |
D149 |
403 (15.8) |
Tensile Modulus,
@ 100% Elongation, psi (MPa) |
D412 |
910 (6.3) |
Tensile Set, % |
D412 |
50 |
Unless otherwise noted, all tests were conducted at room temperature (73ºF). Values shown were determined on 0.075" thick extruded strip or 0.075" thick molded ASTM plaques or molded ASTM durometer buttons.
For complete compliance information, visit www.processsystems.saint-gobain.com
|